How to Build a Wooden Pool Table Cover

A pool table is designed to bring you hours of enjoyment. However, if it is not properly protected, the felt and even the slate are subject to damage. Falling objects like a knocked-over lamp pose a serious and costly risk to your table. Building a simple, wooden pool table cover provides protection from this type of damage. It is also a moderately simple project to build at home.

Instructions

1

Measure the pool table length and width. Most pool tables are 8 feet long and 4 feet wide.

2

Cut a plywood sheet to the length and width you measured. Use a tape measure and ruler to mark the board and a table saw to make the cuts.

3

Dry fit the plywood to the table carefully to make sure it fits.

4

Cut 2-by-4 boards to the length and width you measured in step one. This is for the trim around the edge of the wood pool table cover. Use a table saw to cut these boards.

5

Attach the boards to the edges of the pool table cover using a wood adhesive like liquid nails. Perform this step away from the table, with the plywood resting on the floor or a large bench.

6

Attach a brass handle to the middle of each side on top of the 2-by-4 boards using 1-inch wood screws and a power driver. This is to assist you in lifting the cover off of the pool table.